TriboDyn® Patented 5W-40 Fully Synthetic Heavy Duty Engine Oil has been approved for all street & off road vehicles including high performance & all forms of racing, powerboats and other stationary & mobile equipment. It is a high performance and specially engineered engine oil for heavy duty diesel and gasoline engines operating under all service conditions, including all-season use in diesel powered or a mix of gasoline and diesel powered equipment. It can be recommended for service requirements of virtually all diesels and gasoline engine manufacturers. It can be recommended to both newer and older engines, including L.P.G and natural gas engines. Specifically designed for today’s high performance diesels, including diesels with oil fired injectors and turbocharged engines, and low-emissions diesel engines equipped with Exhaust Gas Recirculation (EGR) and Diesel Particulate Filter. Keeps engines & pistons clean & soot suspended in oil despite longer drain intervals increased soot loading.
TriboDyn® Patented Fully Synthetic Engine Oils are 100% synthetic superior base oils formulated into a complex mixture of extreme pressure lubricants combined with a “High Performance Coating Technology” that is engineered to maximize fuel efficiency, minimize friction & wear, increase part & engine life, reduce operating temperature and perform under extreme pressure & heat. This unique formula also provides continuous protection by dispersing & clinging to critical areas without creating any drag, providing both start up and continuous benefits while protecting against corrosion. The proprietary technology is an “Intelligent” material that is attracted to areas of heat and friction, as pressures increase with RPM or load, the special lubricants combined with the active “Coating”technology in the oil can form a self-lubricating “Ceramic”film in high load & heat areas, providing critical protection that actively seeks out areas needing increased lubrication, and at times not simply reduce or eliminate wear, but can also repair damaged surfaces.
Applications: TriboDyn® Patented 5W-40 Fully Synthetic Heavy Duty Engine Oil meets or exceeds the following service classifications:
API: CJ-4/SN, CI-4 Plus, CI-4, CH-4, CG-4, CF-2, CF, Mack EO-O Premium Plus 07, Mack EO-N Premium Plus 03, Mack EO-M Plus, Caterpillar ECF-3, ECF-1, Cummins CES 20081, 20077, 20076, Detroit Diesel 93K218, 93K215, 93K214, Man 3275, Mercedes Benz 228.3, MTU Type I, TYPE II, Volvo VDS-4, VDX-3, VDS-2, Global DHD-1, JASO DH-2, ACEA E7-04, E4, E2, Allison C- 4, John Deere, Ford Tractors, Allis Chalmers, Massey Ferguson, J.I. Case & Case IH, International Harvester (Diesel & Gasoline), Kubota, and AGCO Tractors. Fully compatible with all other synthetic & petroleum based engine oils.
Directions for use: Follow engine manufacture’s SAE weight recommendations and all other OEM specifications. On all new engines, do not add TriboDyn® Patented 5W-40 Fully Synthetic Heavy Duty Engine Oil until after 1st oil change.
DO NOT USE AS BREAK-IN OIL.
NOT RECOMMENDED FOR ANY WET CLUTCH APPLICATIONS.
WARNING: Contains petroleum distillates. Avoid direct exposure. May cause skin or eye irritation. Ingestions may cause GI tract irritations or stomach discomfort. Inhalation of oil mists or heated oils may results in respiratory tract irritation.
Slip hazard when spilled.
EYES - Flush with water for 15 minutes; get medical attention if eye irritation persists.
SKIN - Wash with soap and water get medical attention if irritation develops.
INGESTION - If swallowed, DO NOT INDUCE VOMITING- Rinse mouth with water; get immediate medical attention.
INHALATION - Remove exposed person to fresh air if adverse effects are observed; get medical attention if symptoms occur.